AcoFiber custom acoustic polyester

Plano can make a local line bend or crease, not a large uniform curve or fold. In the case of creases, the plate is locally heated and bent along a single straight line.

This is possible

Sharp bend with a small inner radius, along a single line. The plate remains flat outside the bending zone.

Not possible

An even radius across the plate. For a large curve, please contact us first.

Please note Always explicitly write 'interior dimensions' or 'exterior dimensions' with the measurements. Without this choice, the dimensions are not unambiguous.

For brushed or textured panels: link the direction to one dimension. Always state 'brushing direction parallel to dimension ... mm'. Only 'horizontal' or 'vertical' is not sufficient.

A. Parallel to 600 mm

The structure runs horizontally, parallel to the long dimension. View the panel straight on (front side).

B. Parallel to 400 mm

Same panel, vertical structure. Both are possible; that is why 'landscape' or 'portrait' is not enough and you state the size in mm.

Please note Do not use only 'horizontal', 'vertical', 'landscape' or 'portrait'. Always mention the corresponding size in millimeters.

Choose the connection and indicate whether you are providing inside or outside dimensions. In the case of butt-joint gluing, Plano determines the production-technical structure.

A. Butt joint / ends glued

One panel continues; the end grain of the other remains visible. Plano determines which part continues.

B. Miter-glued

Both parts are given a bevel and meet at the corner, without an exposed end grain. A fine glue line may remain visible.

Please note Always state 'interior dimensions' or 'exterior dimensions'. Without that choice, the dimensions are not unambiguous.

With only a hypotenuse or a scaled sketch, the shape is not unambiguous. Use the dimension letters: B = total base width, H = perpendicular height, X = apex position.

Top centered

Symmetrical triangle: B = 200 mm, H = 350 mm. The apex lies exactly above the center of B.

Top not centered

Then also provide dimension X: the position of the top, measured from the bottom-left corner.

Please note Measure H is always perpendicular to the base, so not along a slanted side. In case of doubt, include a dimension sketch.

Sawing + drilling: maximum 4 identical holes. All four holes have the same diameter and the same center-to-center position relative to the panel edges.

Sawing + drilling

Panel 750 × 1000 mm with 4 equal holes: one diameter (e.g. 8 mm) and one center-to-center position (e.g. 20 mm, panel edge to center), automatically in all four corners.

Milling or laser cutting needed

More than 4 holes, different diameters or deviating hole positions: choose milling or laser cutting.

Please note Do not specify individual hole coordinates. For a non-standard hole pattern, choose milling or laser cutting.